Automotive  CANBus Warwick Control CAN/OBD Training Kit
|
The CAN & ODB Training Kit consists of:
- Full set of CAN course notes
- Kvaser CAN interface
- X-Analyser 3 Standard
- OBD (male) to 2 x 9-pin DSUB cable
- OBD/ECU simulator
- Carry Case
|
The price of the kit reflects a discounted means of purchasing the above items individually.
 |
Kvaser Leaf Light CAN-HS v2 – This single CAN cannel interface represents one of the easiest and lowest-cost methods of connecting a computer to a CAN bus network. It has a USB 2.0 compliant connector with a 9-pin D-SUB connector. Galvanic isolation as standard. Recommended for use with the X-Analyser 3. |
 |
X-Analyser 3 Standard Edition (Single Channel) – This has all the functions of the ECO with the addition of CAN data base (dbc) and LDF capability. The Standard is single CAN or LIN channel only – dongled from the Kvaser interface serial number. |
 |
ECUSim – Normally sold with the Training Kit but can be purchased separately. This device simulates several ECUs, thus emulating CAN/OBD communication. Is to be used with the X-Analyser 3 for training purposes. Has adjustment potentiometers for signal variation (Engine speed, Engine Temp, Road speed). |
 |
WCT Kit Bag small laptop - Neoprene bag for carrying your portable tech |
 |
OBDII Male to 2 x DSUB Female Connector/Adaptor – Normally supplied with one of the Kits listed. This adaptor cable can be purchased separately. Allows connection to a standard J1962 OBD socket in a vehicle to a CAN interface e.g. Kvaser. An extra Dsub9 connector is supplied for use by a scan tool or adaption to connect to an Oscilloscope.1 x OBD to 2 x Dsub9 – 2 metre cable. |
Order your Training Kit Here:
Go to back to X-Analyzer 3 >>>
|
|
|
|
|
